FRIGIDAIRE 137147900 A - Manual (Page 3)

- EXCESSIVE WEIGHT HAZARD - To avoid
back or other injury, have more than one person move or lift
the washer.
3
C
1
) Attaching washer mounting hardware
WASHER INSTRUCTIONS
D
1
) Mounting washer
E) Installing or re-installing washer
Use the following instructions for mounting either of these types 1.
of washers to the pedestal:
Using two or more persons, slightly tip the washer back and lift it 1.
onto the pedestal. Still tipped, slide the washer back against the
rear brackets and gently set down the front so the appliance is
between the front and rear brackets.
Attach each front clip to outer-most set of holes with 2 screws 2.
and supplied spacer.
Insert “A” tab of each rear bracket into the middle slots on rear 3.
of pedestal. Orient bracket inward for washer mounting.
Adjust the appliance side-to-side to align its mounting holes with 2.
the pedestal’s bracket holes.
Install 2 screws through each rear bracket into the base of the 3.
washer.
With the pedestal drawer open for better access, install a screw 4.
through each front bracket into the base of the washer.
Slide appliance/pedestal into place. 1.
Check for levelness and rock all four (4) legs again. Repeat until 2.
level and solid.
Refer to 3. Washer Installation Instructions for complete details
on installing water, drain, or electrical.
SLIDE BACK
TIP DOWN
middle
slot
inward
Install 2 screws through each rear bracket into aligning pedestal 4.
holes.
Locate spacer under each front bracket.
“A”
tab