Fisher & Paykel OB60 - Manual (Page 26)

24
Sliding shelf supports (some models only)
The telescopic sliding shelf supports can be fitted in the upper or lower oven. The telescopic
sliding shelf supports make it safer and easier to insert and remove the oven shelves and trays.
They stop when they are pulled out to the maximum position. Wipe the supports with a damp
cloth and a mild detergent only. Do not wash them in the dishwasher, immerse them in soapy
water, or use oven cleaner on them.
To remove the sliding shelf supports:
1 Remove the side racks by unscrewing the fixing screws (Fig. 17).
2 Lay down the sliding shelf support and side racks, with the sliding shelf support underneath.
3 Find the safety locks. These are the tabs that clip over the wire of the side rack (arrow 1 in Fig.
21).
4 Pull the safety locks away from the wire to release the wire (arrow 2 in Fig. 21).
To refit the sliding shelf support onto the side racks:
1 Screw the side racks onto the oven wall. Ensure they are the right way up (Fig. 17).
2 Fit the sliding shelf support onto the top wire of a rack and press (Fig. 22). You will hear a click as
the safety locks clip over the wire.
Important!
When fitting the sliding shelf supports, make sure that you fit:
the slides to the top wire of a rack. They do not fit on the lower wire.
the slides so that they run out towards the oven door, as shown in Fig. 22.
both sides of each pair of shelf slides.
both sides on the same level.
Care and cleaning
1
2
1
Fig.21 Removing the sliding shelf supports Fig.22 Refitting the sliding shelf supports