Fisher & Paykel OB60 - Manual (Page 8)

6
Installation instructions
To build in the double oven
Important!
If you are planning to install a cooktop directly above the oven, make sure the installation will comply with
the cabinetry and ventilation requirements of the cooktop as well as those of the oven. Bench heights,
benchtop thicknesses and cooktop installation requirements vary: some cooktops may not be able to be
installed directly above the oven.
Installation “A” between existing side cabinets (560 or 600 mm gap) (Figs. 2a, 2b, 3a, 3c)
Mount the 2 (two) metal supports “B” (supplied with the appliance in a separate kit) as indicated
in Fig. 2b, 3c).
Fig. 3c only, prepare 2 wood uprights “A” (width 20-50 mm, thickness 18 mm, length 650 mm);
mount the 2 wood uprights “A” to the cabinet walls as indicated in Fig. 3c.
Build in the double oven making it slide on the metal supports “B”.
Installation “B” between side cabinets by removing previous housing (Figs. 3b, 3c)
Remove previous housing.
Mount the 2 (two) metal supports “B” (supplied with the appliance in a separate kit) as indicated
in Fig. 3c).
Prepare 2 wood uprights “A” (width 20-50 mm, thickness 18 mm, length 650 mm); mount the 2
wood uprights “A” to the cabinet walls as indicated in Fig. 3c.
Build in the double oven making it slide on the metal supports “B”.
Installation “C” by using housing unit (Figs. 4a, 4b)
Remove the upper cross member support as indicated in Fig. 4a.
Cut the bottom of the housing as indicated in Fig. 4a.
Screw oven base housing to adjoining cabinetry by suitable screws (not supplied) as indicated in
Fig. 4b.
Check the position of the cabinet legs to ensure the cut-out does not interfere with the legs’
support. Otherwise the cabinet may have to be removed as in installation type "B".
Mount the 2 (two) metal supports “B” (supplied with the appliance in a separate kit) as indicated
in Figs. 4b).
Build in the double oven making it slide on the metal supports “B”.
Fixing the double oven
The double oven should then be secured by 6 screws fitted into the holes provided at the sides
of the oven (Fig. 5). If you open the oven doors, you will see some screw holes. Remember the
housing should not be free standing but be secured to the wall and/or adjacent fittings.
Note:
It is essential that when installing your double oven, adequate air circulation is available within
the installation. Inadequate air circulation may greatly impair the performance of your double
oven and may affect adjacent cabinets due to an increase in temperature. Adjust the hinges of
furniture door adjacent to the double oven to allow a 5 - 7 mm gap between the furniture door
and the oven frame.