Fluke 5725A - Manual (Page 20)

5725A
Instruction Manual
1-4
1-2. Where to Go From Here
This manual is the operator and service manual for the 5725A. However, because the
5725A operates under the control of the 5700A Calibrator, most operating instructions
for the 5725A are in the 5700A/5720A Series II manuals. Topics such as selecting output
values, connecting to a UUT (Unit Under Test), and self calibration are covered in the
5700A/5720A Series II Operator Manual. The list below gives some specific pointers,
and the text further on describes how to use all the manuals to find 5725A information.
For More Information About: Refer To:
•
Unpacking and setup Section 2 of this manual
•
Installation and rack mounting Section 2 of this manual and the
Y5735/Y5737 Instruction Sheet
•
AC line power and interface cabling Section 2 of this manual
•
Controls, indicators, and binding
posts Section 3 of this manual
•
5725A service information Sections 4 through 9 of this manual
•
Operating the amplifier Section 3 of this manual and Section 4 of
the 5700A/5720A Series II Operator
Manual
•
Cabling to a Unit Under Test Section 4 of the 5700A/5720A Series II
Operator Manual
•
Self calibration Section 7 of the 5700A/5720A Series II
Operator Manual
•
Full verification Section 3 of the 5700A/5720A Series II
Service Manual
•
IEEE-488 or serial remote operation Section 5 of the 5700A/5720A Series II
Operator Manual
•
5700A/5725A specifications Section 1 of this manual
•
Theory of operation Section 4 and 9 of this manual
•
Troubleshooting Section 6 of this manual
•
Ordering a part Section 8 of this manual