Fluke NETWORK SERVICE MODULE DTX-NSM - Manual (Page 2)

DTX-NSM Instruction Sheet/English
Page 2
Software Requirements
The following software supports the DTX-NSM module. Software upgrades are
available on the Fluke Networks website.
• DTX software: version 1.3 or later
• LinkWare software: version 2.5 or later
Installing the DTX-NSM Module and Optional SFP
Module
Install the network module only on the main tester. Install an optional SFP (small
form pluggable) module to test fiber links. You may install or remove the SFP
module while the tester is on. See Figure 1.
W
Caution
Leave the module bay cover in place when a network module is not
installed.
Put the dust cap on the SFP port when an optical module is not
installed. Put the dust cap on the optical module when not connected
to a fiber.
can01.eps
Figure 1. Installation