Futrex Body Fat and fitness Analyzer -5500A/WL - Manual (Page 15)

15
Prior to conducting the actual body composition analysis, you should locate the proper
measurement site at the biceps of the dominant arm.
1) Have the test subject hold his/her arm straight out, with the elbow locked, and the
palm of the hand facing up towards the ceiling.
2) Using the Biceps Locator (shown below), find the “halfway point” between the armpit
and the inside of the elbow, where the elbow bends (i.e. the acromion). As shown in
the illustration, place the end marked “To Underarm” at the point marked “A.” The
end marked “To Elbow” should extend past the bending point of the elbow towards
point marked “B” in the illustration.
3) Once the Biceps locator is in place as described in step 2, identify the number on
the Biceps Locator that crosses the point “C” on the arm. Point “C” is the place
where the elbow bends.
4) Locate the corresponding number identified by point “D” in the illustration (e.g. if the
number at point “C” is “6,” then find the corresponding “6” at point “D.”) This is the
midpoint, or the “belly” of the biceps.
5) It is recommended that you mark this spot by placing a small line just to the inside
or outside of the spot with a highlighter or washable marker.
Biceps Locator
Placing the
Biceps Locator
Selecting the Measurement Site