FilterStream D4200 - Manual (Page 12)

Duster in and out of the
Vacuum Chamber a few times
(see Figure 6). The
combination of the Dust
Agitation Ring (which loosens
dust with a twisting action) and
suction will most effectively
remove dust from the
Lambswool Duster. The
Vacuum Chamber suction will
run for approximately 8
seconds, then will
automatically turn off to
conserve battery power.
During the above cleaning
cycle, dust and allergens are
being suctioned away and
captured in the Stainless Steel
Pre-Filter and the HEPA Filter
(see figure 7). Only clean,
allergen free air is recirculated
into your home.
If you want to clean the Duster
again, simply remove the
Lambswool Duster from the
Vacuum Chamber and reinsert it,
thereby activating the Infrared
Dust Wand Sensor and turning
the suction on again.
Your Lambswool Duster is now
clean and ready to dust another
room in your house.
CLEANING LAMBSWOOL DUSTER WITH VACUUM CHAMBER
12
1. Your DustTamer Deluxe ®
Vacuum Chamber can be
conveniently carried from
room to room operating on
battery power.
2. The number of times you
clean your Lambswool Duster
in the Vacuum Chamber will
be determined by the amount
of dust you pick up. Rooms
with heavy dust accumulation
may require several cleanings,
whereas small rooms or quick
touch-up dusting may only
require one cleaning.
Note: To keep your Lambswool
Duster free of dust and allergens,
we recommend periodic cleaning
of your Lambswool Duster in
the Vacuum Chamber, even if
dust isn’t visible on the
Lambswool Duster.
To clean your Lambswool
Duster in the Vacuum Chamber,
simply follow these steps:
a. Slowly insert the Lambswool
Duster into the Vacuum
Chamber. The Infrared Dust
Wand Sensor will detect the
Lambswool Duster and
automatically start the suction
action. (see figure 5)
b. Once the suction has started,
slowly move the Lambswool