Fluke LOCAL - Manual (Page 13)

Maintenance
Maintenance and Cleaning
3
3-1
Section 3
Maintenance and Cleaning
To prevent injury, do not remove or insert lamp when unit is energized .
To prevent damage to the lens, do not use abrasive materials or cleaners
Refer the parts lists for the required type of lamp After disconnecting power, replace the
lamp as follows:
1. Insert a small flat blade screwdriver between the INSIDE locking mechanism and
the lens. Gently push down and then pry up while unseating the lens away from
the mounting base. Pull the lens up and off .
To prevent property damage and injury, do not touch glass with bare fingers. Grasp glass with a
soft clean cloth or with packaging supplied with the replacement lamp.
2. Gently push down on the lamp, twist and pull up to remove the lamp from the socket.
Install the new lamp by aligning the connector on the base of the tube with its mating
socket, then carefully press down into the socket. Assemble the Lamp .
3. Apply power to the signal and verify that the signal operates properly .
Periodically clean the beacons lens with a soft cloth or sponge and water or a mild
detergent solution to maintain optimum visibility. Ensure that the lens is completely
dry before assembling the unit .
Refer the parts lists for the required type of lamp After disconnecting power, replace the
lamp as follows:
WARNING
CAUTION
CAUTION