FORD SK5W7J-19A361-AA - Manual (Page 10)

10/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA
Rev Date- 8/29/05
MODULE PREPARATION (Cont’t)
Tape the harness sections together, making sure to cover all of the unused wires.
4
5
Unused wires
Steering column harness
Driver kick panel harness
Referring to the vehicle specific wiring section for the
system being installed, gather all individual wires that
will be routed to the same areas of the vehicle into
groups. Cover each wire group with tape for
approximately 18”. Depending upon the vehicle, there
will be 2 - 5 different wire groups.
Trim the unused wires approximately 6 - 8” from the
module. Do not cut the override/programming button off
of the harness, it is used for all installations.
3” - 4”
2” - 3”