FORD SK5W7J-19A361-AA - Manual (Page 19)

19/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA
Rev Date- 8/29/05
2x
Locate an easy to access area near the drivers side
hood hinge.
Mount the hood safety switch using the supplied sheet
metal screws (BB) so that the switch will be biased
downward when the hood is closed. Route the wire
carefully avoiding any moving parts or excessive heat.
Select a proper grounding point and clean surface of
paint, grease and dirt. Attach ground lug to connection
point using the sheet metal screw provided (BB). Torque
ground screw to 10 in / lbs. Apply rustproofing compound
(Super Seal #F3AZ-19515-SA) to drilled hole.
Note: Ground connection must be tight and secure.
Failure of ground connection can prevent proper
operation of system.
The remaining hood switch wire will be connected during
the wiring steps. Refer to the siren installation steps for
directions on routing this wiring through the bulkhead
panel.
1
2
3
HOOD TILT SWITCH INSTALLATION
10 in / lbs
M
BB
BB