Furuno FS-1562-15 - Manual (Page 10)

-1.2-
1.2 Front View of Transceiver Unit
(Same for FS-1562-15 and FS-1562-25)
S/N:
R
0 2 4 6 8 10 S
H3E
AGC NB
SIMP
1
MODE
2
CURS
3
CLARIFY
TX
4 5
SQ
6
SCAN
RX
7
TX TUNE
8
HI LOW
9 RCL
2182
INTERCOM
0
TEST
ALARM
START
ENT
STOP
SSB TRANSCEIVE FS-1562-15
MIC
OFF
VOLUME RF GAIN FREQ/CH
Loudspeaker Operation Display Keyboard
Xtal oven light
(LED) FREQ/CHANNEL
selector RF GAIN
control Volume control
w/Power ON/OFF Microphone
Hndset Jack
Rotary controls
VOLUME Turns the power on and off and adjust the loudspeaker volume.
When FS-1562 is connected to DB-500 and RB-500, FS-1562 can be turned
on by RB-500.
This is possible with the RB-500 having ROM version 1.04 and after.
RF GAIN Adjusts the receiver sensitivity.
FREQ/CH Changes the frequency in conjunction with the [TX] or [RX] key. Also changes
the channel numbers set with the [RCL] key.
Keys
[1] (MODE) Selects a class of emission and controls AGC on and off. Press the [1] key
repeatedly until the wanted class of emission appears.
[2] (CURSor) Shifts cursor (underline marking). Press the [2] key to move the cursor.
[3] (CLARIFY) Adjusts the receiver frequency for fine tuning when the frequency is set in
terms of Channel NO. Not active in direct frequency entry. The adjustable
range is
±
150 Hz in 10 Hz steps.
[TX] Selects a TX frequency.
[4] (speaker) Turns the internal or external loudspeaker on or off. The speaker mark appears
on the display when the speaker is off.