Fisher-Price DODGE 73520 - Manual (Page 10)

10
• Fit a rectangular bushing (with rectangular opening) onto
the end of the rear axle. Make sure the base on the
rectangular bushing is down, as shown.
• Place a cap nut on a flat surface, inside up, as shown.
Hint: You may want to place a scrap block of wood
underneath the cap nut to protect the assembly surface.
• Fit the rear axle into the cap nut.
• Tap the opposite end of the rear axle with a hammer to
secure the cap nut in the rear axle. Pull on the cap nut to
be sure it is secure.
• Set the rear axle assembly aside for Assembly step 6.
• Turn the vehicle body
over so that the bottom
is facing you.
• Using safety scissors, cut the plastic retainer holding the
motor in place.
• Throw away the plastic retainer.
.437"
Assembly
F
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle’s unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children
should not handle parts, including the
battery, or help in assembly of the vehicle.
WARNING
Vehicle Body
Plastic
Retainer
Motor
Motor
Plastic
Retainer
Rear Axle
Rectangular
Bushing
(with Rectangular
Opening)
.437 Cap Nut
• Identify the rear wheels and the front wheels.
- Rear wheels have a flat center tread.
- Front wheels have a ribbed center tread.
• Select a rear wheel (with flat center tread) and go onto
Assembly step 4.
Flat Ribbed
See
Inset
Bottom View
.437 Cap Nut
Rectangular Bushing
(with Rectangular
Opening)
Base
2
1
3
Rear Wheel Front Wheel
73520 Dodge Ram 6/27/01 2:56 PM Page 10