FUJITSU FD-1008AT - Manual (Page 16)

13
Connecting and Removing Cables
Read the Console Drawer manual before connecting the cables. Do
not connect or remove the cables during a thunderstorm. When
unplugging cables hold them by the plug, not the cable. Connect and
remove cables in the following order.
Connecting Cables
● Getting started
Then confirm that the power cable for each server is plugged into an electric o
utlet and that the power is off. (Confirm connection (1))
● Connect the servers
2.1 When using one level KVM Switch (using only one switch device)
It is possible to hook up a maximum of 8 servers.
1) Connect the first server’s keyboard, mouse connector and CRT connector with
the special cable (connect (2)), next connect the switching device’s Mini D-Sub
15 pin (female) to the special connector (black). (connect (3)). Use the fixing
screws to hold the Mini D-SUB15Pin in place.
2) Connect hosts 2 through 8 in the same manner.
3. Connect the console
3.1 Connect the monitor cable and keyboard/mouse cable to the keyboard and mouse
connectors. (connect (4)) Note: Do not connect the cables to the connectors
marked with an x.
4. Connect the power cable
4.1 Connect the power cable to the Console Drawer. Next, connect the power cable to an
earthed power supply outlet.
When connecting the connector (Mini D-SUB 15Pin) for the monitor, use
the fixing screws to securely connect the connector to the Console Drawer
and server. Otherwise, images may be distorted.
CAUTION