FUJITSU MB91460 SERIES User Manual
FUJITSU Computer Accessories
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Revision History
- Warranty and Disclaimer
- Contents
- 1 Introduction
- 1.1 Abstract
- 1.2 Features
- 1.3 General Description
- 1.3.1 On Board Memory
- 1.3.2 MCU Clocks
- 1.3.3 MCU Operating Mode
- 1.3.4 FlexRay CC Clock
- 1.3.5 FlexRay CC-MCU Connection
- 1.3.6 External Bus interface Connectors
- 1.3.7 FlexRay Physical Layer
- 1.3.8 CAN Bus
- 1.3.9 RS-232 and LIN
- 1.3.10 MCU Pins
- 1.3.11 User Buttons
- 1.3.12 User LEDs and optional LCD
- 1.3.13 Power Supply
- 2 Installation
- 3 Jumpers and Switches
- 3.1 MCU Operating-Mode (S5)
- 3.2 FlexRay CC Operating-Mode (S2)
- 3.3 FlexRay CC SPI Settings (S1)
- 3.4 Power Supply
- 3.5 MCU-FlexRay CC Connection at SK-91F467-FLEXRAY
- 3.6 FlexRay Physical Layer
- 3.7 CAN0 – CAN2
- 3.8 LIN / RS-232 UART
- 3.9 User Push Buttons INT0, INT1, INT2 and ICU0/TIN0
- 3.10 User DIP Switch 8 Bit (S4)
- 3.11 Reset Generation
- 4 Connectors
- 4.1 Power Connector (X5)
- 4.2 UART / LIN Connector (X1, X4, X8)
- 4.3 CAN Connector (X9, X10, X11)
- 4.4 FlexRay Connector (X2, X6)
- 4.5 FlexRay Physical Layer Module Connector (X3, X7)
- 4.6 USER-LEDs and optional LC-Display (D1-D16, J6)
- 4.7 In-Circuit-Programming Connector (X12)
- 4.8 MCU Pin Connectors (J1-J4)
- 4.9 External Bus Connectors (X13, X14)
- 5 Getting Started
- 6 Flash Programming
- 7 Trouble shooting
- 8 Silk-Plot of the Board
- 9 PCB History
- 10 Appendix