FUJITSU MB91460 SERIES - Manual (Page 51)

SK-91F467-FLEXRAY V1.1
Getting Started
© Fujitsu Microelectronics Europe GmbH - 51 - FMEMCU-UG-910017-11
Start Softune Monitor Debugger via the “Debug” Command
Figure 5-6: Start Softune Workbench Monitor Debugger
10. After the project is built and debugged successfully switch to the active configuration
STANDALONE
5.2.3 Use Active configuration STANDALONE
11. With this selection the project is linked to work in internal flash memory. This
configuration will not work with the Softune Workbench monitor debugger. In this
configuration the code is linked to work in internal Flash memory, only.
12. Use “Make”, or “Build” to compile and link the project for internal Flash memory. The
generated output files can be found in the sub-folder STANDALONE of the project
folder. The *.mhx file (Motorola S-Record) is located in the ABS sub-folder.
13. Program the generated *.mhx file (Motorola S-Record) with the Flash programming
utility into the internal Flash. See Chapter 6.1 “Programming the internal Flash
Memory” for more details.
Note:
Always check the memory map of the linker settings and ensure
that this memory map is suitable for the application and target
system in use. Additionally the *.mp1 file should be checked to
ensure correct settings.