3 jumpers and switches, 1 mcu operating-mode (s5), Mcu operating-mode (s5) – FUJITSU MB91460 SERIES User Manual

Page 19

Advertising
background image

SK-91F467-FLEXRAY V1.1

Jumpers and Switches

© Fujitsu Microelectronics Europe GmbH

- 19 -

FMEMCU-UG-910017-11

ON

OFF

Dip-Switch S5

(default setting)

1

2

3

4

MD0 MD1 MD2 nc

3 Jumpers and Switches

This chapter describes all jumpers and switches that can be modified on the starter kit. The
default setting is shown with a grey shaded area.

3.1 MCU Operating-Mode (S5)

The DIP-switch S5 is used to set the operating mode of the MCU. Ensure that the mode pin
settings correspond to the operation-mode of the application. For more detailed information
please check the Hardware-Manual of the microcontroller.

DIP switch

Setting

Logical value

ON (closed)

1 (high)

S5/1 (MD0)

OFF (open)

0 (low)

ON (closed)

1 (high)

S5/2 (MD1)

OFF (open)

0 (low)

ON (closed)

1 (high)

S5/3 (MD2)

OFF (open)

0 (low)

ON (closed)

Not connected

S5/4 (Not used)

OFF (open)

Not connected

Default: grey

Table 3-1: MCU Operating Mode

By default, the “Single Chip Run-Mode” of MB91F467DA is selected.

Figure 3-1: MCU Mode Switch

Advertising
This manual is related to the following products: