FUJITSU MB91460 SERIES - Manual (Page 61)

SK-91F467-FLEXRAY V1.1
Flash Programming
© Fujitsu Microelectronics Europe GmbH - 61 - FMEMCU-UG-910017-11
6 Flash Programming
6.1 Programming internal Flash of MB91F467DA series
To program the Monitor debugger or any other Application into the internal Flash memory of
MB91F467DA series following steps must be taken.
1) To install the Flash Programming utility on the PC the following steps must be taken
a. Browse to the folder “Software\FlashProgramming” of the starter kit CD-ROM
and execute the FME_FR_Flashprogrammer_v3_7.exe file. The default
installation folder is: C:\Softune6\Utility\
b. Start Flash Programming tool by double click flash.exe within the installed
folder: C:\Softune6\Utility\FME_FlashProgrammer_v3_7\flashprg.exe
2) Open the Flash programming Utility by double click the flashprg.exe file
3) Select CPU type, COM Port, baud rate, Hex File as shown in the following figure
a. Device Type: MB91F467D
b. Com port: 1
c. Baudrate: 38400
d. Hex File: MonDeb91467D.mhx
Use button “Browse” and browse to
c:\..\Software\MonitorDebugger\ MonDeb91467D.mhx
Figure 6-1: FME FR-Flash Programmer for MB91F467D series
c
d
6
a