FUJITSU MB91460 SERIES - Manual (Page 8)

SK-91F467-FLEXRAY V1.1
Introduction
FMEMCU-UG-910017-11 - 8 - © Fujitsu Microelectronics Europe GmbH
1.2 Features
• Supports 32-bit Flash microcontroller MB91F467D
• Supports FlexRay CC MB88121
• 9-12V (2000mA) unregulated external DC power supply
• 5V, 3.3V, 2.5V and 1.8V on-board switching regulators with power status-LEDs
• Triple supply monitor to watch 5V, 3.3V and selectable 2.5V or 1.8V
• On-board Memory:
o 32Mbit (4MByte) SRAM
• It is possible to connect the FlexRay CC in different ways to the MCU
• 16 bit non multiplexed / multiplexed bus
• 8 bit non multiplexed / multiplexed bus
• SPI communication
• All microcontroller resources available for evaluation
• All microcontroller pins routed to pin header
• In-Circuit serial Flash programming
• Three selectable RS-232 or LIN UART-interfaces
• Three High-Speed CAN interfaces
• Two FlexRay channels (Ch-A, Ch-B)
• FlexRay physical layer RS-485 available
• FlexRay physical layer driver module from TZM (FT1080) connectable
• 16 User LEDs
• optional: alphanumeric standard LC-Display connectable
• Reset button, Reset-LED
• 4 User buttons, one 8 bit MCU port can be connected to DIP switches
• External bus interface routed to 96pin and 48pin DIN 41612 (VG) connectors
This board must only be used for test applications
in an evaluation laboratory environment.