FUJITSU MB91460 SERIES - Manual (Page 45)

SK-91F467-FLEXRAY V1.1
Getting Started
© Fujitsu Microelectronics Europe GmbH - 45 - FMEMCU-UG-910017-11
5 Getting Started
Make sure Softune Workbench for FR is installed on your PC and the “SK-91F467-
FLEXRAY” or “SK-91F467D-208PFV” is ready to use (power-on (X5), serial connection
(UART4) to COM port of the PC). Refer to Chapter 2 Installation for details on the hardware
and software installation.
5.1 Introduction to Softune Workbench
Start Softune Workbench. Select <File> <Open Workspace> to load the first example “SK-
91F467-FLEXRAY_test.wsp”. All examples can be found in the folder \software\examples on
the starter kit CD-ROM. It is recommended to copy this folder to the local hard-drive. In the
project tree on the left side, you can open the “source”-folder which contains the source-files
registered to this project. A double-click on one of the files will invoke the built-in editor,
which supports syntax-highlighting, tags and various other functions.
Figure 5-1: Softune Workbench main window
Note:
You may customize the editor by a right-click on the editor
window.