Fujitsu Siemens Computers N3010 - Manual (Page 8)

8
L i f e B o o k N S e r i e s N o t e b o o k B I O S
Secondary Master Submenu of the Main Menu
The Secondary Master submenu allows you to configure secondary ATA devices.
Figure 3. Secondary Master Submenu
Table 3: Fields, Options and Defaults for the Secondary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: ■ Auto
■ None
■ CD-ROM
■ Hard Disk
[Auto] NOTE: The Type field does not appear as a drop-down menu. Tap
the spacebar to cycle through the selections.
Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM,
SuperDisk or Hard Disk for appropriate drive type installed at
this connection.
CHS Format Cylinders/Heads/Sectors
Cylinders: ■ A number between
0 and 65,535
–— This item appears only when Hard Disk is selected as the type. This
field is changed by incrementing (pressing the [Spacebar]) or by typ-
ing in the number.
Heads: ■ A number between
1 and 16
–— This item appears only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
Sectors: ■ A number between
0 and 63
–— This item appears only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Secondary Master [TOSHIBA DVD-ROM SD-R2412]
Type: [ Auto ]
Multi-Sector Transfers: [Disabled]
LBA Mode Control: [Disabled]
Transfer Mode: [Standard]
Ultra DMA Mode: [Disabled]
▲