First Alert HS-4700-S - Manual (Page 11)

7
Setting Up
Your HS-4700-S System
This chapter provides instructions on installing and connecting the cameras supplied with the
system and connecting the DVR.
I NSTALLING AND C ONNECTING THE C AMERAS
Here are some general safety and installation tips when installing the cameras:

Do not attempt to open a camera. There are no user-serviceable parts inside.
Refer servicing to qualified service personnel.

When using power tools wear safety goggles. Before drilling holes through a
wall or ceiling, check for hidden electricity cables and water pipes.

When installing a camera on an external wall, pass the power cable through the
wall as close as possible to the camera to reduce the chance of tampering. After
drilling any hole though an external wall for cable, make sure the hole is sealed
around the cable.
1 Select the position for the camera and install a mounting bracket (supplied).
Screws and anchors are supplied. Use an appropriate screw type for the mounting surface.
2 Screw the camera onto the bracket. Tighten the lock nut to secure the camera on
the bracket.
3 Adjust camera to the proper view angle. Make sure the lens is upright relative to your
subject. Tighten the thumb bolt.
thumb bolt
camera mounting bracket
lock nut