Fender Power Stage 100 - Manual (Page 5)

5
L. SUPPLY CORD JACK - The
supply cord connects here. This is a
grounding type supply cord to
reduce the possibility of shock
hazard. Be sure to connect it to a
grounded receptacle. DO NOT
ALTER THE AC PLUG. M.POWER SWITCH - Turns the
AC power ON and OFF. When
the switch is in the OFF position,
the PowerStage 100 is
completely shut down.
A. PHANTOM - When this button is
pressed, a +15 V D.C. Phantom
Power supply is activated,
necessary for some condenser style
microphones. Before plugging or
unplugging any microphone, make
sure the Phantom Power supply is
off.
B. MIC 1 IN - Plug your
microphone in here. This three pin
XLR balanced female input
connector is intended for input
signals from low impedance
microphones.
C. MIC 2 IN - An additional
balanced microphone input for the
PowerStage 100. Both the M
IC 2 IN
and the I N S T jack can be used
simultaneously, however, any
adjustments to the M
IC 2 / I NST
control knob will affect the volume of
both the Mic 2 and Instrument inputs.
D. AUX. LINE - A 1/4 inch TRS
balanced input jack suited for use
with items having a line level output.
Both the
AUX LINE and the STEREO
L I N E jack can be used
simultaneously but remember, any
adjustments to the
AUX LINE / STEREO
L I N E control knob will affect the
volume of both the AUX LINE / STEREO
LINE inputs.
E. INSERT - A 1/4 inch unbalanced
TRS input / output phone jack
designed for use with signal
processing devices, such as a digital
delay or a reverb unit. A special "Y" line cord (stereo
to 2 mono) is required to use this jack. On the
PowerStage 100, the tip is the send and the ring is
the return.
F. PHANTOM POWER LED - This
LED illuminates when the phantom
power supply is on.
G. POWER LED - This LED
illuminates when the PowerStage
100 is on.
H. MIC 1 OUT - This three pin XLR
balanced male output connector is
used to send the
MIC 1 input signal
unmodified out to a mixing console.
I. INST - A 1/4 inch TS unbalanced
input jack suited for use with
instrument level signals such as an
acoustic guitar, a keyboard or a drum
machine. Remember, any
adjustments to the M
I C 2 / I N S T
control knob will affect the volume of
both the Mic 2 and Instrument
inputs.
J. STEREO LINE - These are
unbalanced phono (RCA) input jacks
designed for use with a stereo tape
player, CD player, etc. These jacks
produce a mono signal out and are
useful for playing prerecorded
music. Adjustments to the
AUX
LINE / STEREO LINE control knob will
affect the volume of both the AUX
LINE / STEREO LINE inputs.
K. LINE OUTPUT - A 1/4 inch TRS
unbalanced output jack designed to
feed the optional PowerStage
Xpander 100.
INPUT PANEL FUNCTIONS
M
D
B
F
G
H
C I
J
K E
L
POWER SECTION
A