Franklin Industries, L.L.C. FIM400 4100 - Manual (Page 20)

19
5. When you want to clean the machine, turn off the power switch first, then turn it on
again. Press the Clean button within 3 minutes and the ice maker will start the
cleaning mode, with harvest and ice-making indicators blinking. After 30 minutes, the
cleaning mode stops and the harvest indicator and ice-making indicators are on steady.
If you want to restart the ice-making process after cleaning, turn off the power switch
first and drain off the waste water, then turn on the power switch again and the
machine will automatically go into the ice-making process.
6. If you want to interrupt the cleaning mode before it is finished, do not press the Clean
button again. Instead, turn the power switch off. This stops the cleaning cycle.
7. If the machine is on but only the power indicator light is lit, this may indicate that not
enough water is reaching the system, that the water pump is not functioning, or some
similar problem. First check the level in the water tank, then examine the water pump,
etc.
8. If the unit is connected to the power supply but no visual indicator lights up when the
power switch is turned on, the fuse in the control panel box may need to be replaced.
Descriptions of LEDs and buttons:
1. Ice Full (white) LED: Ice Full indicator light
When this LED is on, the ice storage bin is full of ice cubes or there is something
obstructing the ice-full probe. The unit will stop working. When ice cubes are
removed from the ice storage bin, clearing the ice-full probe, the white LED will flash
for 3 minutes. Then the unit will restart and return to the ice-making mode.
2. Ice Making (Green) LED: Ice Making indicator light
When this LED is on, the unit is in the ice-making mode.
3. Ice Harvest (Yellow) LED: Ice Harvest indicator light
When this LED is on, the unit is working in the ice harvest mode controlled by the
ice-full probe.
4. I. S. adjust: Ice size adjustment
Turn the screw clockwise, and the size of individual ice cubes will be larger in the
next cycle; the cycle time will be longer. Turn the screw counter-clockwise, and the
ice cube size will be smaller in the next cycle.
5. Power switch
This is the main switch. When it is turned on, the unit starts working after 3 minutes.
The power indicator LED is on.
6. Clean button
If you press the Clean button within three minutes after the power has been turned on,
the ice maker will enter the cleaning mode. The green and yellow LEDs will be
blinking together.
IMPORTANT:
? It is not recommended that the ice size be adjusted unnecessarily since this could
damage the machine’s controls.
?
Avoid letting water contact the control box.