FUJITSU FTP-624MCL303 - Manual (Page 3)

3
FTP-624MCL303/304/FTP-624DSL113
For head
Voltage: 4.2-8.5 VDC
Peak current: approx. 2.6 A (conditions: room temp., 7.2 VDC, 64 dots on)
For motor
Voltage: 4.2-8.5 VDC
Peak current: approx. 0.8 A (conditions: room temperature, 7.2 VDC)
For logic
Voltage: 5.0 VDC
±
5%
Current: 0.2 A maximum
For cutter Voltage: 5.0 VDC
±
5%
Current: Approximately 5.0A (in-rush)
Approximately 1.0A (average)
Mechanism 97 (W)
×
57 (D)
×
38 (H) mm
Dimensions
Interface board 131 (W)
×
89 (D)
×
24 (H) mm
Weight (Mechanism) Approximately 280 g
Mechanism Pulse durability: 1
×
10 8 pulse/dot (using Fujitsu Takamisawa's standard
driving method)
Expected life Wear resistance: 50 km (at 25% print ratio)
Cutter 300,000 cuts minimum
Operating temperature 0 to +50
°
C* 1
Operating humidity 20 to 85% RH (no condensation)
Storage temperature –20 to +60
°
C (excluding paper)
Storage humidity 5 to 95% RH (no condensation)
Head temperature By thermistor (applied energy control, abnormal temperature detection)
Detection Paper out/Mark detect By photointerrupter
Head-up By microswitch
For front insertion use (58 mm width) : FTP-020PU001, FTP-020P0104/
P0701
For rear insertion use (60 mm width) : FTP-020P0020, FTP-020P0105/
P0702
Recommended thermal sensitive paper
In Europe (58 mm width) : FTP-021P0060-45
· Oji Paper : PD150R, PD160R-N, PD170R
· NIPPON Paper : TF50KS-E4,TF60KS-E,TF50KS-E
· MITSUBISHI Paper Mills : P220VBB-1, AFP-235
Specifications Item
(Continued)
Power
supply
Environmental
conditions
*1: Guarantee +5
°
C to +40
°
C.