Furuno Network Sounder DFF3 - Manual (Page 23)

3. INITIAL SETTINGS
16
3.2 DIP Switch Setting
The DIP switch S2 sets up the system according to the equipment connected. In the default setting
all switches (1-8) are OFF. The DIP switch S3 should not be adjusted; leave all switches in the
OFF position.
DIP switch S2 description
*1: Power sync setting enabled at NavNet 3D.
Switch
No.
Function Setting
1 Power on/off by NavNet or NavNet
3D
OFF: Power sync (for NavNet 3D)
*1
ON: No power sync (for NavNet)
2 Automatic/Manual IP address
selection OFF: Automatic IP address assignment. Use this
setting for NavNet 3D.
ON: Manual IP address assignment. Use this setting
for NavNet, and refer to the table on the next page for
IP addresses.
3 - 6 Manual IP address assignment Valid when switch no. 2 is ON. For connection of mul-
tiple network sounders, assign each one an IP ad-
dress with the Mode DIP switch, referring to the table
on the next page.
7 Restore default settings (other than
LAN and transducer) See section 4.3.
8 Restore ALL default settings See section 4.3.
DIP Switches
1-8
ON OFF
S2
S3
1-8
ON OFF