FUJITSU FR family 32-bit microcontroller instruction manuel CM71-00101-5E - Manual (Page 256)

232
CHAPTER 7 DETAILED EXECUTION INSTRUCTIONS
Example: COPLD #15, #4, R8, CR1
16-bit data is transferred through the bus to the coprocessor indicated by channel number 15. Next,
the contents of general-purpose register "R8" are transferred through the bus to that coprocessor.
Assuming that the coprocessor indicated by channel 15 is a single-precision
floating-decimal calculation unit, the coprocessor command "CC" set as shown in Table 7.117-1
will have the following effect on coprocessor operation.
Table 7.117-1 Conditions for Coprocessor Command "CC" (COPLD)
CC Calculation
00 Addition CRi + CRj
→ CRi
01 Subtraction CRi – CRj
→ CRi
02 Multiplication CRi × CRj
→ CRi
03 Division CRi ÷ CRj
→ CRi
Other No calculation
MSB LSB
0 0 0 0 0 1 0 0 1 0 0 0 0 0 0 1
R8 3 F 8 0 0 0 0 0
(CPU register)
R8 3 F 8 0
3 F 8 0
0 0 0 0
(Coprocessor register)
(CPU register)
(Coprocessor register)
CR1 x x x x x x x x CR1 0 0 0 0
Before execution After execution