Fluke ESA612 - Manual (Page 71)

Electrical Safety Analyzer
Cleaning the Analyzer
57
F1 - F2
fis111.eps
Figure 35. Fuse Access
5. Using a multimeter, measure the continuity of each
fuse.
If one or both fuses do not show continuity, replace
the fuse(s) with fuses that have the same current and
voltage rating. Appropriate fuse ratings are posted on
the case bottom label of the Analyzer. Table 6 lists
available fuses with Fluke Biomedical part numbers.
6. Reinstall the fuse door and secure it with the screw.
Cleaning the Analyzer
XW Warning
To avoid electric shock, do not clean the
Analyzer plugged into mains or attached to a
DUT.
W Caution
Do not pour fluid onto the Analyzer surface;
fluid seepage into the electrical circuitry may
cause the Analyzer to fail.
W Caution
Do not use spray cleaners on the Analyzer;
such action may force cleaning fluid into the
Analyzer and damage electronic components.
Clean the Analyzer occasionally utilizing a damp cloth and
mild detergent. Take care to prevent the entrance of
liquids.
Wipe down the adapter cables with the same care. Inspect
them for damage to and deterioration of the insulation.
Check the connections for integrity before each use.