First Alert FA168C - Manual (Page 16)

– 16 –
$UPLQJWKH6\VWHP
6LQJOH%XWWRQ$UPLQJ
The “A”, “B”, “C”, and/or “D” keys on your keypad may have been programmed for
single-button arming. Note that while it will not be necessary to use a security code
for arming, a security code must always be used to disarm the system.
If Single-Button Arming is programmed:
•
A function key has been assigned to a specific type of arming: STAY mode,
Night-STAY mode, AWAY mode, or STEP-ARMING (see Step-Arming
paragraph).
•
You DO NOT need to enter your user code before pressing the function key
(you always need your user code to DISARM the system).
Before arming, close all perimeter doors and windows.
1. Press and hold the assigned function key for 2
seconds (no code is required). Function keys are
shown below.
3 2 1
6 5 4
9 8 7
# 0 *
READY
INSTANT
OFF
CODE
AWAY
TEST
CHECK
STAY
BYPASS
A
B
C
D
ADT3000-007-V0
Alpha Display:
(-7%61)(
6)%(= 83 %61
Fixed-Word Display: READY
2. The keypad begins beeping and displays the armed
message. The red ARMED indicator also lights.
Alpha Display:
%61)(%;%=
=39 1%= )<-8 23;
Fixed-Word Display: AWAY
6WHS$UPLQJ)HDWXUH
Single-Button “Step” arming may have been programmed into one of the lettered keys
(A, B, C, or D). Check with your installer to see if this has been done in your system.
If Step-Arming is programmed:
•
The assigned key provides a choice of three levels of security.
•
The selected key can be pressed once, twice, or three times, increasing the level
of security with each press, as follows
Key
Ø
First Press
Ø
Second Press
Ø
Third Press
Ø
A, B, C, D
Armed-STAY Armed Night-STAY
(if programmed)
Armed-AWAY