First Alert FA168C - Manual (Page 26)

– 26 –
3DJLQJ)HDWXUH
$ERXW$XWRPDWLF3DJLQJ
Your system may be set up to automatically send alert messages to several pagers (up
to four for FA168C, up to two for FA148CP) as certain conditions occur in your system.
•
The following events can be programmed by your installer to be sent to the pagers:
arming and disarming
† , alarms, and trouble conditions. ( † reports when
arming/disarming from a keypad using a security code; auto-arming/disarming,
arming with assigned button, and keyswitch arming do not send pager messages.)
•
You can also program the system to send an automatic pager message to alert you
in the event that someone has not arrived home (disarmed the system) within a
defined period of time (see the Scheduling section for details on programming a
“latch key report”).
•
Your installer programs the pager phone numbers and reporting events.
•
The pager message consists of a 7-digit system status code that indicates the type of
condition that has occurred.
•
An optional, predefined 16-digit character string can precede the 7-digit system
status code; these characters can consist of a PIN no., subscriber account no., or any
additional data that you may wish to have sent to the pager.
•
The pager display format is as follows:
3-digit Event Code
И И
Optional 16 digits Ж Ж AAAAAAAAAAAAAAAA – BBB – CCCC Е Е 4-digit User or Zone No.
A = B = C =
Optional 16-digits for
Account numbers,
PIN numbers, or any
other data;
programmed by the
installer, if required. A 3-digit code that
describes the event
that has occurred
in your system
(see for event
codes table below)
A 4-digit User or Zone number, depending on the type of
event that has occurred, where:
• alarms and troubles display zone number
•
arming/disarming (opens/closes) display user number
The first 2 digits are always “00” (e.g., 0004 represents
zone or user number 4), and, single-digit user or zone
numbers are always preceded by a zero.
The 3-digit Event Codes (BBB) that can be displayed are:
911 = 811 = 101 = 102 =
Alarms.
The 4-digit number
(CCCC) following this
code is the zone number
that has caused the
alarm.
Troubles.
The 4-digit number
(CCCC) following this
code is the zone number
that has caused the
trouble.
Open
(system disarmed).
The 4-digit number
(CCCC) that follows
this code is the user
number that has
disarmed the system.
Close
(system armed).
The 4-digit number
(CCCC) that follows
this code is the user
number that has armed
the system.
Examples of typical 7-digit pager displays follow.
Ex. 1 .
³
= R eporting of an alarm (911) caused by a fault on zone 4 (0004).
Ex. 2. ³ = Reporting of a closing–system arming (102)– by user 5 (0005).