Furuno GP-30/35 - Manual (Page 38)

7-7
3. Press the [ENT] key.
SAVE WP/RTE
ALL WYPTS/ROUTES
WILL BE SAVED TO PC.
SET PC PORT TO 4800
8 BIT, P-N, S1, XON/XOFF.
CONTINUE?
Figure 7-15 SAVE WP/RTE display
4. Press the [ENT] key.
SAVING START?
(PC READY?)
ARE YOU SURE?
YES NO
Figure 7-16 SAVING START? prompt
5. Operate the computer to receive data
there.
6. Press the [ENT] key.
WYPTS & ROUTES
SAVING....
CANCEL?
SAVING
COMPLETED.
HIT ANY KEY.
Data is being
saved. To can-
cel, press the
[ENT] key.
Data is saved
completely.
Hit any key to
escape.
saved.
Figure 7-17 Displays when
downloading data
7. Press any key to escape.
Uploading from PC
Note that all waypoint and route data stored
in GP-30/35 will be deleted when data is up-
loaded.
1. Open the I/O SETUP menu.
2. Select LOAD WP/RTE
←
PC?.
3. Press the [ENT] key.
LOAD WP/RTE
LOADING ERASES CUR-
RENT WP/RTE DATA.
SET PC PORT TO 4800
8 BIT, P-N, S1, XON/XOFF.
CONTINUE?
Figure 7-18 LOAD WP/RTE display
4. Press the [ENT] key.
LOADING START?
(PC READY?)
ARE YOU SURE?
YES NO
Figure 7-19 LOADING START? prompt
5. Press the [ENT] key.
Note: The waypoint and route data are
deleted when the [ENT] key is pressed.
WYPTS & ROUTES
LOADING....
CANCEL?
Preparing for
data loading.
Figure 7-20 Display when data
is being loaded
6. Operate the computer to output data from
the computer
7. When data loading is finished, the fol-
lowing message appears.
LOADING
COMPLETED.
HIT ANY KEY.
Figure 7-21 Display when data
is loaded successfully
8. Press any key to escape.