Franklin Industries, L.L.C. FBC36ID - Manual (Page 8)

When the correct temperature appears in the DISPLAY window of the control panel, press
SET to confirm. Remember that each compartment has separate controls so you will need
to set the temperature in each compartment separately.
PLEASE NOTE: Cold air falls and warmer air rises, and there will be a small temperature
variation from the bottom to the top of the unit. The temperature sensor is located in the
middle of each compartment and records the temperature at that point. The temperature at
the bottom of the unit will always be slightly colder.
Drip Tray
At the rear of the unit, near the bottom, you can see a plastic tray positioned above the
compressor. This tray catches water that condenses inside the appliance. Heat from the
normal operation of the compressor should evaporate the water that collects in the tray.
Interior Lights
Each compartment has an interior light that can be turned on or off by pressing the
ON/OFF button located on the left side of each control panel. It is not a good idea to leave
these lights on for too long. They can raise the internal temperature of the compartments.
For instructions on replacement of bulbs, see page 8.
Compressor Run Indicator
When your unit
’s compressor is running, either one or both control panels will display
moving icons representing a running fan. If the compressor stops running, the icons will
stop running as well.
Memorizing Temperature Settings
Your unit has been designed to
“remember” the last run mode to which it was set. If you
suffer a power outage or any other power cutoff, the unit will automatically return to the
previous temperature settings after power is restored.
About the Liquid Crystal Display (LCD)
When you press any key, a blue backlight will appear in the Display Panel. If no other key
is pressed, the backlight will automatically go out after 2 minutes.
In the event that there is a fault in the unit, an ALARM indication will appear on the screen.
ALARM Mode
In ALARM mode, the unit will make a beeping sound and display an alarm message. If the
LCD on the control panel displays any of the following messages: PROBE ERROR, LOW
TEMP or HIGH TEMP, consult the
Troubleshooting section of this manual.
Racks, Basket and Shelving
The wine racks, flat shelves and wire baskets in your unit are chrome-plated so they will
not rust. The wine racks pull out only 1/3 of the way; this is a safety feature so that neither
the machine nor the rack will tip over. The flat shelves do not pull out. Space between
racks and shelves is adjustable.
7