Fluke PN 3612805 User Manual
Page 7
Clamp Meter
Safety
Information
3
•
Remove the test leads from the Meter before the battery door is opened.
•
Examine the test leads for damaged insulation or exposed metal. Check test lead
continuity. Replace damaged test leads before using the Meter.
•
Do not use the Meter if it operates incorrectly. Protection can be compromised.
When in doubt, have the Meter serviced.
•
Do not use the Meter around explosive gas, vapor or in damp or wet
environments.
•
When measuring, keep fingers behind the Tactile Barrier. See "The Meter" .
•
Use only type AA batteries, properly installed in the Meter case, to power the
Meter.
•
To avoid false readings that can lead to electrical shock and injury, replace the
batteries as soon as the low battery indicator () appears.
•
When servicing the Meter, use only specified replacement parts.
•
Have the Meter serviced only by qualified service personnel.
•
Be careful around voltages > 30 V ac rms, 42 V ac peak, or 60 V dc. Such
voltages pose a shock hazard.
•
Do not apply more than the rated voltage, as marked on the Meter, between the
terminals or between any terminal and earth ground.
•
When using the probes, keep fingers behind the finger guards on the probes.