Disassembly instructions, 1 mechanical parts – Friedrich KP05A10 KP06A10 User Manual

Page 5

Advertising
background image

—5—

2. DISASSEMBLY INSTRUCTIONS

2.1 MECHANICAL PARTS

2.1.1 FRONT GRILLE

1. Pull the inlet grille forward.
2. Remove the screw securing the Front Grille. (Fig. 3)
3. Push the grille up from the bottom and pull the top of

the grille away from the case to lift the top tabs out of
their slots. (Fig. 4)

4. Carefully position the grille, bottom first, and snap back

into place.

5. Reposition the screw that secures the front grille and

replace the knobs.

2.1.2 CABINET

1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to section 2.1.1)
3. Remove 9 screws that secure the cabinet to the

base pan and condenser. (See Figure 3)

4. Lift the cabinet from the unit.
5. Re-install by referring to the procedures above.

2.1.3 CONTROL BOARD

1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 2.1.1)
3. Remove the cabinet. (Refer to Section 2.1.2)
4. Remove 1 screws that secure the control board to

base pan and air guide. (See Figure 4)

5. Pull the control board toward yourself.

6. Disconnect one housing terminal and 3 wires for

the fan motor and compressor. (See Figure 5)

7. Re-install components by referring to procedures

above. (Refer to wiring diagram on page 23 in this
manual or inside control board.)

Figure 1

Figure 2

Figure 3

Figure 4

Figure 5

NOTE : Controls, wires, and capacitor are now

accessible for servicing. Discharge the
capacitor before servicing. See step
2.3.3 on page 8 for procedures.

Advertising