2 air handling parts – Friedrich KP05A10 KP06A10 User Manual

Page 6

Advertising
background image

—6—

2.2 AIR HANDLING PARTS

2.2.1 AIR GUIDE UPPER

1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 2.1.1)
3. Remove the cabinet. (Refer to Section 2.1.2)
4. Remove the control board.

(Refer to Section 2.1.3)

5. Remove 2 screws that secure the air guide upper

to air guide lower. (See Figure 6)

6. Lift air guide upper upward.
7. Re-install by referring to the procedures above.

2.2.2 ORIFICE, TURBO FAN AND FAN

1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 2.1.1)
3. Remove the cabinet. (Refer to Section 2.1.2)
4. Remove the control board.

(Refer to Section 2.1.3)

5. Remove the air guide upper.

(Refer to Section 2.2.1)

6. Remove 2 screws that secure the base pan to

condenser. (See Figure 7)

7. Remove screw that secures the shroud to

channel of condenser.

8. Press the snap area of shroud with your thumbs.

This allows you to remove it from the condenser.

9. Lift the compressor upward with the evaporator

and condenser. (See Figure 7)

10. Remove the orfice by pushing the snap area of

the air guide blower. (See Figure 8)

11. Remove the clamp springs which are clamped to

the boss of fan and turbo fan by hand plier. (See
Figure 9)

12. Pull the fan and turbo fan outward.
13. Remove the shroud.
14. Re-install by referring to the procedures above.

Figure 6

Figure 7

Figure 8

Figure 9

Advertising