Fujitsu Siemens Computers LifeBook S2210 - Manual (Page 60)

49
U s e r - I n s t a l l a b l e F e a t u r e s
EXTERNAL MONITOR PORT
The external monitor port allows you to connect an
external monitor. In order to connect an external monitor
follow these easy steps: (Figure 4-22)
1. Open the flexible cover over the external monitor
port.
2. Align the connector with the port opening.
3. Push the connector into the port until it is seated.
4. Tighten the two hold-down screws, located on each
side of the connector.
Figure 4-22. Connecting an External Monitor
MINI S-VIDEO OUT JACK (TV OUT)
The S-Video jack allows you to connect and use directly
any S-Video device, such as a VCR or television. The
S-Video standard provides for a higher quality picture
than NTSC or PAL. In order to connect an S-Video
device, follow these easy steps: (Figure 4-23)
1. Attach the mini S-Video cable adapter (Figure 2-3)
(included with your system accessories) to the S-
Video cable from the device.
2. Align the connector with the jack opening.
3. Push the connector into the jack until it is seated.
Figure 4-23. Connecting an S-Video Device
INFRARED PORT
The Infrared IrDA (4Mbps) port allows for wireless data
transfer between your notebook and other IrDA-
compatible devices, such as another computer or a
printer, without the use of a cable. (See figure 2-7 on
page 10 for port location)
It is important to keep in mind that while carrying out
this form of communication, both devices must be
placed so their infrared ports are directly facing each
other without obstruction. The devices must also be
separated by at least 6" but no more than 36" for
maximum performance.
The following conditions may interfere with infrared
communications:
■ A television, radio remote control unit, or a wireless
headphone is being used nearby.
■ Direct sunlight, fluorescent light, or incandescent light
shines directly on the port.
Pressing the [Fn] + [F10] keys allows you
to change your selection of where to send
your display video. Each time you press the
key combination, you will step to the next
choice, starting with the built-in display
panel only, moving to the external monitor
only, finally moving to both the built-in
display panel and an external monitor.
■ Do not move either device while com-
munication is active as it may interrupt
data transmission.
■ Be careful not to scratch the infrared
port lens. Dirt, scratches, or other sur-
face marks can degrade operation.