Fujitsu Siemens Computers LifeBook S2210 - Manual (Page 65)

54
L i f e B o o k S 2 0 0 0 N o t e b o o k
TROUBLESHOOTING TABLE
Problem Page
Audio Problems . . . . . . . . . . . . . . . . . . . . . . . . . . page 55
DVD/CD-ROM Drive Problems. . . . . . . . . . . . . page 55
Floppy Disk Drive Problems . . . . . . . . . . . . . . . . page 56
Hard Drive Problems . . . . . . . . . . . . . . . . . . . . . . page 56
Keyboard or Mouse Problems. . . . . . . . . . . . . . . page 56
Memory Problems . . . . . . . . . . . . . . . . . . . . . . . . page 57
Modem Problems . . . . . . . . . . . . . . . . . . . . . . . . . page 57
Problem Page
USB Device Problems . . . . . . . . . . . . . . . . . . . . . page 57
PC Card Problems . . . . . . . . . . . . . . . . . . . . . . . . page 57
Power Failures . . . . . . . . . . . . . . . . . . . . . . . . . . . page 57
Shutdown and Startup Problems . . . . . . . . . . . . page 59
Video Problems . . . . . . . . . . . . . . . . . . . . . . . . . . page 60
Miscellaneous Problems . . . . . . . . . . . . . . . . . . . page 61
Problem Possible Cause Possible Solutions
Startup and Shutdown Problems
Windows Vista Users:
The first time you initialize
your Windows Vista
system, the screen is blank
for approximately two
minutes.
This is normal. After initialization, a “Set Up Windows” dialog box
will appear. Follow the instructions that appear.
Important: During the setup procedure, do not
disconnect the power supply, press any buttons, or
use any peripheral devices such as a mouse,
keyboard, or remote control.
The Suspend/Resume
button does not work. The Suspend/Resume button is
disabled from the Advanced
submenu of the Power menu of
the setup utility. Enable the button from the setup utility.
You did not hold the button in
long enough. Hold the button longer. This may need to be a few
seconds if your application is preventing the CPU
from checking for button pushes.
There may be a conflict with
the application software. Close all applications and try the button again.
The system powers up, and
displays power on informa-
tion, but fails to load the
operating system. The boot sequence settings of
the setup utility are not
compatible with your
configuration. Set the operating source by pressing the [ESC] key
while the Fujitsu logo is on screen or use the [F2]
key and enter the setup utility and adjust the source
settings from the Boot menu. (See BIOS Setup
Utility on page 27 for more information)
You have a secured system
requiring a password to load
your operating system. Make sure you have the right password. Enter the
setup utility and verify the Security settings and
modify them as accordingly. (See BIOS Setup Utility
on page 27 for more information)
Internal hard drive was not
detected. Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try to
auto detect the internal hard drive.
An error message is
displayed on the screen
during the notebook
(boot) sequence. Power On Self Test (POST) has
detected a problem. See the Power On Self Test (POST) messages to
determine the meaning and severity of the problem.
Not all messages are errors; some are simply status
indicators. (See Power On Self Test Messages on
page 62 for more information)