Final Sound S100 - Manual (Page 6)

Contents Copyright 2006 Final Sound Solutions.
5. CONNECTING THE S100 TO YOUR SYSTEM
ALWAYS SWITCH OFF YOUR SYSTEM BEFORE CONNECTING ANY WIRES!
To increase the versatility of connecting up, the S100 has various separate high and low level inputs .
5.1 High Level Inputs
Make sure your entire system is powered off .
Use a second set of speaker wires from your amplifier output to connect to the S100 .
Connect the right amplifier output to the right high level input; connect the left amplifier output to the left high
level input .
Connect the positive amplifier output to the red binding post; connect the negative amplifier output to the black
binding post .
Ensure that the speaker wire is completely seated in the amplifier outputs and the subwoofer’s high level inputs
before turning on any component .
5.2 Low Level Inputs
Make sure your entire system is powered off .
For stereo connection, use a pair of RCA cables .
For mono/LFE/SUB-OUT use a single RCA cable .
Connect one end of the RCA cables to the proper output of your receiver/preamplifier/processor .
Connect the other end of the RCA cables to the line level inputs of the subwoofer .
Ensure that the RCA cables are fully seated in all connectors before turning on any component .
6