Final Sound S100 - Manual (Page 7)

Contents Copyright 2006 Final Sound Solutions.
6. ADJUSTING THE S100
Set the S100 in the desired location .
Connect the S100 to the stereo system (chapter 5) .
Set the volume control to a minimum, the crossover frequency to 40 Hz, and the phase to 0 degrees .
Turn on the stereo with music you are familiar with .
Turn up the subwoofer volume to a level that matches the main speakers .
Adjust the phase control to a maximum bass output .
Readjust the volume control .
Turn up the crossover frequency until the location of the bass becomes obvious, or the bass from the subwoofer
overwhelms that from the main speakers .
Readjust the volume control .
If you have a dedicated stereo/surround setup guide/disc, refer to the directions included in it .
Note that you may need to try more than one location to reach optimum results .
7. OPERATIONAL GUIDELINES
As with all Final products, the S100 is designed to provide the highest level of performance . However, the S100 still
has limits that should be observed .
If the S100 begins to overload or heavily distort, turn down the bass or volume .
If the S100 overwhelms the output of the main speakers, turn down the volume .
If the main speakers sound strained, raise the S100 crossover frequency .
If the bass sounds loose or dislocated, adjust the phase or placement of the subwoofer until the problem disappears .
Placement of the subwoofer within the room is critical to the operation of the S100 . Recommended locations
include the center of the front wall, either front corner, or the center of the side walls .
If the S100 malfunctions, turn the subwoofer off and on . If the problem persists, contact your dealer for additional
troubleshooting .
7