FUJITSU Siemens CELCIUS M/V/R - Manual (Page 35)

Troubleshooting and tips
A26361-K990-Z120-1-7619, Edition 6 27
Screen, stays blank
Cause Troubleshooting
Monitor is switched off. ► Switch your monitor on.
Power saving has been activated
(screen is blank) ► Press any key on the keyboard.
or
►
Deactivate the screen saver. If necessary, enter the
appropriate password.
Brightness control is set to dark ► Adjust the brightness control. For detailed
information, please refer to the operating manual
supplied with your monitor.
Power cable not connected ► Switch off the monitor and the device.
► Check that the monitor power cable is properly
connected to the monitor and to a grounded mains
outlet or to the monitor socket of the device.
► Check that the device power cable is properly
plugged into the device and a grounded mains
outlet.
► Switch on the monitor and the device.
Monitor cable not connected ► Switch off the monitor and the device.
► Check that the monitor cable is properly connected
to the device and monitor.
► Switch on the monitor and the device.
Wrong monitor has been set under
Window XP ► Restart the device.
► Press F8 while the system is booting.
Either the Windows Advanced Start Options menu or the
menu for selecting the operating system appears.
►
If the menu for selecting the operating system
appears, press F8 .
► Select Safe Mode or Safe Mode with Network.
► Set the correct values for the attached monitor as
described in the operating manual of the monitor by
selecting Start - Settings - Control Panel - Display and
then the Appearance, Themes, Settings tabs.