FUJITSU Siemens CELCIUS M/V/R - Manual (Page 71)

System upgrades
A26361-K990-Z120-1-7619, Edition 6 63
Installing an accessible drive
► Open the casing (see "Opening the casing").
► If a slide-in module is fitted, remove this first. To do this, proceed in the same way as when
removing an accessible drive (see "Removing an accessible drive").
!
Do not dispose of the empty slide-in module. For cooling, protection against fire, and in
order to comply with EMC regulations, you must refit the empty slide-in module if you
remove the drive again later.
► Take the new drive out of its packaging.
► Make the desired settings on the new drive (if necessary, to the settings of drives already
installed as well (Master/Slave)).
2
2
1
► Slide the accessible drive into the casing as far as the stop (1).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Fasten the drive into place with the screws (2).
► Close the casing (see "Closing the casing").
i
It may be necessary to modify the entry for the drive in the BIOS Setup.