Fluke TRACKERTM 90100 - Manual (Page 19)

Operation
Operation Instructions
2
2-7
Figure 2-6. The Model 35360A TRACKER Display Front Panel
Power
The POWER button toggles the system power on or off.
Test/Detector
The TEST/DETECTOR button displays and sequences the Test/Detector screens.
Units Select
The UNITS SELECT button displays the Units Select screen. Subsequent presses toggle the
measurement units between dose and dose rate units.
Air Density
The AIR DENSITY button displays the Air Density screen. Subsequent presses advance the cursor
through the temperature, pressure, and Air Density Correction Factor (ADCF) fields.
Gain Select
The GAIN SELECT button displays the Gain Select screen. Holding the GAIN SELECT key for three
seconds toggles the 35360A TRACKER Display between the Gain Setting and Normal Operation
modes. In the Gain Setting Mode, pressing the GAIN SELECT button advances the cursor through the
Front Panel Gain Factor (FPGF) fields.
Measure Select
The MEASURE SELECT button displays the Measurement screen. Subsequent presses toggle the
display mode between absolute and percentage presentations.
Reset
The RESET button zeroes all measurement readings when dose units are selected. This button
displays the Measurement screen if it is not already displayed.
Up
The UP button function depends on the displayed screen. It increments the temperature, pressure, or a
front panel gain. It toggles the state of the air density correction annunciator or the front panel gain
annunciator. For the Test/Detector screen or the Measurement screen, it displays the previously
displayed screen.
Down
The DOWN button function depends on the displayed screen. It decrements the temperature,
pressure, or a front panel gain. It toggles the state of the air density correction annunciator or the front
panel gain annunciator. For the Test/Detector screen or the Measurement screen, it displays the next
screen.
TURN POWER OFF
PRIOR TO CONNECTING
AND DISCONNECTING
DETECTOR CABLE
TRACKER DISPLAY Model 35360A Radiation Measurements