Fluke TRACKERTM 90100 User Manual
Page 44
Model 90100
Operators Manual
4-8
WARNING
NOTE
1. Position the instrument on its display face.
Figure 4-6. Model 35360A TRACKER Display Fuse Replacement
2. Remove the fuse drawer. With your fingernails, squeeze together the two ends of the fuse drawer
and pull it out of its slot.
3. Replace the fuses with IEC 127 type FST5X20, 0.63 A, 250 V time-lag fuses.
Use only the recommended fuse type. The use of
a higher current rating than specified above may
cause damage to the instrument, which will void
any or all warranties currently in effect.
4. Place the fuse drawer back into its slot. Press on the fuse drawer firmly until it snaps back into
place. Both sides of the fuse drawer should snap into place.
If fuses continue to blow - return instrument for
repair.
!
DETECTOR INPUT
COMPUTER
INTERFACE
RS-232
100-240V 50/60 Hz 50VA
Fuse Drawer
Model 35360A
Rear Panel
TRACKER Display
Fuse Drawer
Fuses