FOCUS Enhancements SXGA - Manual (Page 23)

TView Micro SXGA User’s Guide
Chapter 2 19
6. Turn the TView Micro SXGA on.
7. Turn the television on. If the cables have been connected
correctly, the image from the computer monitor should now
appear on the television screen.
Connecting the TView Micro SXGA to
a VCR
In certain configurations, the video will be run through a VCR.
Therefore the unit must be connected to the VCR. By connecting the
TView Micro SXGA unit, you will also be able to record the computer
screen to videotape.
To connect your TView Micro SXGA to a VCR,
perform the following steps:
1. Connect one end of the supplied composite video cable to the
“Comp Video” port located on the side of the TView Micro SXGA
unit, or connect the male end of the S-Video cable to the port on
the side of the TView Micro SXGA labeled "SCART/S-Video.”
2. Connect the other end of the composite cable or S-Video cable
to the port at the rear of your VCR labeled "Video Input" or
“AUX-IN,” “AV-IN,” or “S-VIDEO IN.”
3. Turn on the VCR.
4. Turn on your television and tune it to channel 3 or 4.
5. Turn the TView Micro SXGA unit on.
6. Turn the computer on.