FARGO electronic HDP600 - Manual (Page 272)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 7-61
Reviewing the Verification options
Use this option, which instructs the Printer to verify that all magnetic data has been correctly
encoded on each card. (Note: With either of these options, the number of verification retries
may be specified. A range of 1-5 retries is available.)
Step Procedure
1 Select the Auto Eject 1st Error option, which instructs the Printer to
automatically eject a card containing magnetic data (that was not verified).

Only the first mistakenly verified card will be automatically ejected. If a
second consecutive card cannot be verified, the Printer will signal an
error and go into Guide eject mode.

The auto eject option is the most direct means of dealing with mistakenly-
verified cards, but may be undesirable (if batch printing) since
mistakenly-verified blank cards are ejected into the same stack as
verified printed cards. (Note: This does not apply when using the
Laminator or Reject Hopper.)
OR
Select the Manual Eject Each Error option so the Printer will signal an error
on its LCD Display stating that the magnetic data could not be verified.
(Note: When this occurs, press the Cancel soft key to Guidely eject the
mistakenly verified card. This option is helpful since Magnetic Stripe
verification can sometimes require more than a single pass.))