FARGO electronic HDP600 - Manual (Page 338)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 12-7
Updating the LCD Firmware
Step Procedure
1 Make sure the Printer is powered ON, connected to the PC and in its READY
mode.
2 From the Firmware Updater program, click on the Select Update File button.
3 Go to the folder, in which you saved the update file, select it and click Open.
The file name, location and version will appear in the Firmware Updater
window, as shown below.
4 Click on the Select Printer button and select the specific Fargo Printer
model, click OK.
5 Click on the Send Update button to bring up the Firmware Updater dialog
box, as shown below.
6 Wait a few minutes while the Firmware updates itself. Check the Printer's
LCD for the status. When the update is complete, the LCD will indicate if the
update was successful.

If Upgrade Successful is displayed, click Exit on the Sending Update
to Printer dialog screen. Press the Printer's EXIT button. When
prompted, turn the Printer power OFF for a few seconds and then back
ON to complete the update process. As the Printer restarts, you will see
the new Firmware version appear on the LCD.

If the upgrade was not successful, the LCD will display Upgrade Failed
or Upgrade Firmware Now on boot up.

If you receive this message, try updating the Firmware again.