Freecom Technologies Storage Gateway NETWORK HARD DRIVE - Manual (Page 79)

79
GB
4
4.2.5 Start recovery procedure
This procedure can reset and repair an FSG to factory default settings if you cannot
access your FSG anymore. Your user data will not be deleted!
To restore your settings, please proceed as follows:
a) Enable the Recovery mode by clicking 'Start the recovery procedure' in the Freecom
Storage Gateway Wizard.
b) Turn the FSG off using 'Shutdown'.
c) Unplug the FSG's AC power pack.
d) Use a pointed object to carefully press the 'Reset' button. It is located next to the AC
power slot on the back of the FSG.
e) Keep the 'Reset' button pressed down and reattach the AC power supply.
f) Release the 'Reset' button.
g) The LED on the PWR button lights up, indicating that the Recovery mode is enabled.
The device's LED flashes while the recovery process is taking place.
h) Once the LEDs stop flashing and the LED on the PWR button turns off, the recovery
process is complete. A message window appears on screen, telling you that the
recovery is finished.
i) Once it is complete, press OK in the Freecom Storage Gateway Wizard window.
The Freecom Storage Gateway Wizard