Regular maintenance, Warning, Maintenance – Ferris Industries 5901180 User Manual

Page 38: Battery maintenance, Anti-scalp deck casters

Advertising
background image

36

www.ferrisindustries.com

Maintenance

Regular Maintenance

BATTERY MAINTENANCE

NOTE: This unit is equipped with a maintenance-free
BCI58 battery)

Cleaning the Battery and Cables

1. Disconnect the cables from the battery, negative

cable first (A, Figure 26).

2. Remove the battery retainer strap (C).

3. Remove the battery and clean the tray and

surrounding areas with a solution of baking soda
and water.

4. Clean the battery terminals and cable ends with a

wire brush until shiny.

5. Reinstall the battery and reattach the battery

cables, positive cable first (B).

6. Secure the battery with the retainer strap (C).

7. Coat the cable ends and battery terminals with

petroleum jelly or non-conducting grease.

Figure 26. Battery Compartment
A. Negative (-) Cable & Terminal
B. Positive (+) Cable & Terminal
C. Retainer Strap

WARNING

Be careful when handling the battery. Avoid
spilling electrolyte. Keep flames and sparks
away from the battery.

When removing or installing battery cables,
disconnect the negative cable FIRST and
reconnect it LAST. If not done in this order, the
positive terminal can be shorted to the frame
by a tool.

FRONT

C

A

ANTI-SCALP DECK CASTERS

The anti-scalp deck casters (A, Figure 27) will aid in
preventing the mower deck from scalping or gouging
the turf while mowing or turning.

The casters can be adjusted in 1/2” (1,3 cm)
increments with the spacers (B). The desired position
is just below the leading edge of the deck.

IMPORTANT NOTE: These casters are not intended
to be in contact with the ground at all times. If you
are mowing at a low cut height, adjust the casters up
to prevent the casters from carrying the weight of the
deck.

A

C

B

B

Figure 27. Anti-Scalp Deck Casters
A. Deck Caster
B. Spacer
C. Lynch Pin

B

Advertising
This manual is related to the following products: