Furuno MU-155C - Manual (Page 17)

11
3.3.2 Changing the signal name
You can change the signal name which is shown on the DISP or PIP window, described in
the next chapter. It is useful to use the name of the device connected (ex. “FCV-1200L”).
For detailed information about these windows, see Chapter 4.
1. Press the [MENU] key to show the main menu.
2. Press the [◄] or [►] key to select OSD.
OSD menu
3. Press the [▲] or [▼] key to select the signal to change its name in CUSTOM NAME
area. In the example above, RGB1 is chosen.
4. Press the [►] key to select the character you want to change. In the example below, “G”
is selected.
5. Press the [▲] or [▼] key to select appropriate alphanumeric character. In the example
below, “5” is selected.
6. To change another signal name, press [◄] and then press [▲] or [▼] to select it.
7. Press the [MENU] key to close the menu.
CUSTOM NAME
RGB1 = R G B1______
RGB2 = RGB2______
DVI = DVI________
VIDEO1 = VIDEO1____
VIDEO2 = VIDEO2____
VIDEO3 = VIDEO3____
RGB1 RGB2 DVI VIDEO1 VIDEO2 VIDEO3 OSD SYSTEM
H_POSITION 15 (1 – 29)
V_POSITION 37 (1 – 37)
TRANSLUCENT OFF (OFF/ON)
CUSTOM NAME
RGB1 = RGB1______
RGB2 = RGB2______
DVI = DVI_______
VIDEO1 = VIDEO1____
VIDEO2 = VIDEO2____
VIDEO3 = VIDEO3____
CUSTOM NAME
RGB1 = R 5 B1______
RGB2 = RGB2______
DVI = DVI________
VIDEO1 = VIDEO1____
VIDEO2 = VIDEO2____
VIDEO3 = VIDEO3____
CUSTOM
NAME area