FARGO electronic DTC400 - Manual (Page 77)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-20
Resolving a Ribbon Sensor Error (Ribbon Miscue) (continued)
Step Procedure
2 Open the front cover and remove the Ribbon Cartridge.
a. Check that the Ribbon is in good condition and not wrinkled or broken.
a. If Ribbon is broke or wrinkled, repair the Ribbon and wind up the take-
up roll 4-color panels past the damaged area.
3 Press on the Resume button.
If the issue persists, continue to Step 4.
4 Replace the Ribbon Cartridge.
a. Press on the Resume button.
b. If the issue persists, continue to Step 5.
5 Press the Cancel Print button on the Driver Monitor Error Display Message.
6 Reboot the Printer by cycling the power.
7 Using the driver calibration tab calibrate the Ribbon Sensor.
If the issue persists, continue to Step 8.
8 Replace the Ribbon Sensor.