FUJITSU DYNAMO 640FE - Manual (Page 27)

1.24
Q2: I cannot access the MO disk.
A2: – Is the MO disk properly formatted for your PC?
– Is the MO disk properly inserted? Eject the disk and reinsert.
– Does the Busy Indicator stay on for a long time (1 minute) after MO
disk insertion? If so, your disk may be dirty or your DynaMO drive
may be defective. Try another MO disk.
Q3: I cannot eject a disk.
A3: – Is the DynaMO icon correctly selected?
– Your PC may have the MO disk locked. Check your computer
applications to ensure that they have not locked your MO disk.
– Is your DynaMO attached to the PC? The eject button is active
while the DynaMO is connected to a PC.
– You may reboot the system.
– Use the emergency eject (see Page 1.16).
Q4: Can I use the DynaMO on Windows NT, Windows 3.1, Windows 95,
or Windows 98?
A4: You can use the DynaMO only on Windows 98 Second Edition or
above.
Q5: To connect the DynaMO to a PC, which IEEE1394 I/F card can I use?
A5: An IEEE1394 I/F card that conforms to the OHCI specification is
required. For details, inquire a manufacturer or a distributor of an
IEEE1394 I/F card.
for Macintosh users
Q1: After inserting an MO disk, it is not mounted in the desktop (no drive
icon appears on the desktop).
A1: – Is the DynaMO correctly connected?
– Check that the FireWire version is 2.0 or above.
– Did you correctly install the DynaMO device driver?
– Is your disk correctly formatted as Macintosh format (HFS or
HFS+)?